Enterprise Name: Jiashan Wang Machinery Co., Ltd.
Contact person: Manager Zhang 15921811816
General Wang 13806713135
Address:Zhejiang Company-No. 9, Lane 31, Jiashan, Zhejiang
Guangxi Agency-No。 425, Chenxiong Mechatronic City, Nanning, Guangxi
It is believed that many practitioners of the first touch sawing machine or drum full-automatic sawing machine want to know what problems should be paid attention to in the process of operation, how to use the sawing machine correctly so as to avoid excessive consumption of the machine and shorten its service life. Then the following hot press manufacturers will introduce the sawing machine and drum self-contained. What problems should be paid attention to in the cutting operation of the moving edge saw?
Before starting the plywood sawing machine, attention should be paid to check whether the pressure of heat conducting oil meets the requirements of the process rules, whether the oil level of the tank is normal, and if the abnormality occurs, it should be replaced in time.
In the future, only when the blade is idle and stable, can it be cut by trial. It is forbidden to start the blade when the blade touches the scrap material. It is forbidden to stop the rolling of the blade during the cutting. It is necessary to exit the blade before the blade can stop turning. When cutting, if the scrap is found to be swaying, the cutting should be stopped immediately. After fixing the scrap firmly, the operation can be continued, and in cutting, no scrap is allowed to move arbitrarily. If there is obvious deceleration or even clamping phenomenon, it may be the reasons of belt slipping, loose pressing nut or too deep cutting tool, too fast cutting speed and so on, which should be adjusted in time.
Before every use of plywood sawing machine, we should check whether the equipment is in normal operation, to ensure that the parts are not loosened and aging, we need to tighten the maintenance equipment which is often coated with lubricating oil in time, so as to reduce the problems.
Fully automatic vertical and horizontal sawing machine is a widely used processing machine in wood panels, and in terms of its operation structure, what is it?
Before sawing with a large saw, a slot is cut at the bottom of the plate by a small saw. When sawing with a large saw, the lower part of the side edge of the plate will not be rough. It also includes a pre-grooving device, which includes a motor and a small axle seat separated from the side and top of the trawler bracket of the frame, a small sawpan axle on the small axle seat, a small sawpan fixed at one end of the small sawpan axle, and a small sawpan corresponding to the front part of the large sawpan, and its movement direction is opposite to that of the large sawpan, and a small sawpan axle fixed at the other end. A belt pulley, a small belt pulley is connected by a belt to a belt pulley at the end of the motor shaft of the motor.
The motor, big axle base, belt pulley, belt and saw installed on the trailer board of the frame should be well maintained, and the maintenance work should be done for each part in the process of operation.